how to use A4-water laminator

how to use A4-water laminator

1 joint in-waterpipe and out-waterpipe

2.joint water pump in order

3.put jointed water pump and waterpipe in the water box, let the whole machine be in the water

4.join the power source of water pump and laminator

5.revolve the handwheel open anti-clockwise

6.send out model board and steel board

7.put 15 pieces of printing paper on the model board

8.put a piece of steel board in it, then put film with glue on the steel board. Pay attention to let the surface of glue towards on.

9.put the basic materials on the film

10.then put the printing materials on it, the surface for printing towards on

11.put the film with glue on it, rubber surface of film downfords

12.then put another steel board, you can put many layers of materials using the same methods(less than 10 layers)

13.then put 15 pieces of printing paper and a steel board on it

14.put the model board filled with all the materials into the mouth

15.revolve the hand wheel tight clockwise(the more layers the more pressure)

16. plug on ,(pay attention that the power must be more than 16A), press the power button

17.when the measuring appliance shows the current temperature, you must adjust the temperature and time pressing setting-up button..

18.TH is upper limit temperature, press up or dowm button to adjust the temperature.(usually at 115-135 centigrade)

19.dt is for extending time, press up and down button to adjust(usually in 15-60s)

20.TL is lower limit temperature, press up and down button to adjust.(usually at 50-60 centigrade)

21.At is for waking-up time, press up and down button to adjust time in the same way.(usually in 30s)

22.press the setting-up button to confirm the revised number so that we can save the number.(go back the current number)

23.now, the temperature begin to rise up, begin to extend, and then begin to low down.

24. when the temperature get the upper limit temperature, now the wind machine and water pump begin to work automatically.

25. when you hear the bell, you can shut down the power source.

26.press the button of power source.

27.revolve the hand wheel open anti-clockwise

28.take out the model board

29.wait for a while in order to let the temperature low down, then take out pressed PVC, then do cutting and locating and punching.

30.when this operation is over, set the model board and steel board in order.(aviod abrasing the steel board) and plug off